Zebex Z-3191LE Barcode Scanner

How to Configure a Zebex Z-3191LE Barcode Scanner

Note: You will require the ProgrammingGuide Zebex CcdLaser.pdf in order to configure the scanner. The entire process should take no more than 5-10 minutes per scanner. The page numbers listed below are the page numbers as dislayed in the ProgrammingGuide Zebex CcdLaser.pdf. The page numbers will differ when attempting to print individual pages in Windows. The programming guide can be downloaded from here: ZEBEX Programming Guide (External Website).

On page 7, scan the barcode labeled Start of Configuration.
On page 7, scan the barcode labeled Reset (return to factory defaults).
On page 7, scan the barcode labeled End of Configuration.
On page 24, scan the barcode labeled Start of Configuration.
On page 24, scan the barcode labeled Keyboard terminator---none.
On page 24, scan the barcode labeled End of Configuration.
On page 29, scan the barcode labeled Start of Configuration.
On page 29, scan the barcode labeled Full ASCII code 39.
On page 29, scan the barcode labeled End of Configuration.
On page 53, scan the barcode labeled Start of Configuration.
On page 53, scan the barcode labeled Header (Preamble).
On page 60, scan the barcode labeled Full ASCII---STX.
On page 53, scan the barcode labeled Confirm to save this setting (required for reading full ASCII table and length setting).
On page 53, scan the barcode labeled End of Configuration.
On page 53, scan the barcode labeled Start of Configuration.
On page 53, scan the barcode labeled Trailer (Postamble).
On page 60, scan the barcode labeled Full ASCII---ETX.
On page 53, scan the barcode labeled Confirm to save this setting (required for reading full ASCII table and length setting).
On page 53, scan the barcode labeled End of Configuration.
Please repower your scanner by disconnecting from P.C and then reconnecting.

To check that the scanner has been correctly configured, go to http://www.fieldpine.com/report/pos/tests/barcodetester.htm and follow the instructions..